| Sensing method |
Diffuse-reflective |
| Sensing distance |
0 to 700 mm (White paper 200*200mm) |
| Differential distance |
20% Max. of sensing distance |
| Light source |
Infrared LED (880nm) |
| Power supply voltage |
10 to 30 VDC (ripple(p-p) 10% included) |
| Current consumption |
35mA DC Max. |
| Control output (Output type) |
PNP open collector output |
| Control output (Load current) |
0 to 100 mA |
| Control output (Residual voltage) |
(DC) 1 V Max. (Load current 100mA Max.) |
| Operation mode |
Light-ON/Dark-ON selectable |
| Load power supply voltage |
30 VDC Max. |
| Protective circuit |
Surge suppressor
Output short-cut protection
Power supply reverce polarity protection
Mutual interference prevention |
| Response time |
0.5 ms Max. |
| Sensitivity setting |
2-turn endless adjustment(with indicator) |
| Ambient illuminance |
Incandescent lamp:5000 lux Max., Sunlight:10000 lux Max. |
| Ambient temperature |
Operating: -25 to 55 CEL
Storage: -40 to 70 CEL
(with no icing or condensation) |
| Ambient humidity |
Operating: 35 to 85 %RH
Storage: 35 to 95 %RH
(with no condensation) |
| Insulation resistance |
20 M OHM Min. at 500 VDC between charged parts and the case |
| Dielectric strength |
1000 VAC at 50/60 Hz for 1 minute between charged parts and the case |
| Vibration resistance |
10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions |
| Shock resistance |
500m/s2 for 3 times each in X, Y, and Z directions |
| Degree of protection |
IEC60529: IP67 |
| Applicable standard (EC Directive (Low Voltage Directive)) |
EN60947-5-2 |
| Applicable standard (EC Directive (EMC Directive)) |
EMI: EN60947-5-2
Emission Enclosure: EN55011 Group 1 classA
EMS: EN60947-5-2
Immunity ESD: IEC61000-4-2
Immunity RF-interference: IEC61000-4-3
Immunity Burst: IEC61000-4-4
CE marking: Equipped |
| Connection method |
M12 connector models |
| Indicator |
Light indicator(red), Stability indicator(green) |
| Mass (packed state) |
approx. 50 g |
| Tightening torque |
0.5 N.m Max. (with M3 screw) |
| Material (case) |
PBT |
| Material (lens) |
Denatured polyarylate |
| Material (mounting bracket) |
Stainless steel(SUS304) |
| Accessories |
Instruction manual, Mounting bracket, Sensitivity adjustment driver, Sensitivity adjusting knob, Close-mounting plate (only for Sensors with connector terminals) |
